Dynon D10/D100

The Dynon D10 and D100 are legacy Dynon EFIS units. OnSpeed supports their serial output format.

Serial Setup

• Baud rate: 115200 (must be configured on the Dynon)
• Protocol: Similar text format to SkyView
• EFIS Type setting: DYNOND10

Wiring

Same as Dynon SkyView — connect the Dynon serial TX to OnSpeed RX (GPIO 11).

Data Available

The D10/D100 provides similar data to the SkyView: IAS, pitch, roll, altitude, and heading. Some fields available on the SkyView (like Percent Lift or engine data) may not be present depending on your specific D10/D100 configuration.

Configuration

1. Set EFIS Type to DYNOND10 in the OnSpeed web interface
2. Configure the D10/D100 serial output for 115200 baud
3. Verify data flow with the SENSORS console command

Check your Dynon manual

Serial output configuration varies between D10 and D100 models. Consult your specific unit's installation manual for serial port setup instructions.